Setup Instructions

​

​1. Put the cannon on its tripod (Two legs should face away from the direction the foam will be going)

2. Attach the swivel handle to the cannon.

3. Put up barricades in front of the cannon and bin, secure with provided weights.

4. Connect the short hose to the cannon securely.

5. Plug in the yellow GFCI pigtail into an outlet, plug in the extension cord, and then cover with water proof casing.

6. Put an on-off valve on the end of the water filling hose.

7. Begin to fill the water bin making sure the filling hose is at the bottom and secured to the barrel with the clamp.

8. Stand the pump in the water.

9. Connect the power for the pump and cannon to the extension cord reel (Leave turned off).

10. Keep the hose below water level, near the bottom away from the pump, to avoid foam forming in the bin.

11. As the bin fills to half way, add the foam solution per  instructions.

12. When the water is near the top turn the hose off. Do not attempt to move the bin when full.

13. Put the cannon red switch in the on position #1, and then turn on the extension cord reel. To turn off, switch off the reel.

​

Pro Tips

​​
1. Keep an eye on water level. You will want to refill your water bin when it is half empty and then add additional solution per instructions. The machine can remain running while you refill, but you may notice the foam output being thinner until the refill is complete. 

2. If it's windy, aim the foam cannon downward to keep the foam in place and keep it from blowing back on the the person operating the machine.

3. To correct thin watery foam, add small amounts of solution slowly.

4. Too much foam?!? You can stop and start the cannon and pump at anytime with the extension cord reel.